Chiron FZ 08 KS Magnum machining centre
Brügg6903 km to "United States/Columbus"
If you decide to buy equipment at a low price, make sure that you communicate with the real seller. Find out as much information about the owner of the equipment as possible. One way of cheating is to represent yourself as a real company. In case of suspicion, inform us about this for additional control, through the feedback form.
Before you decide to make a purchase, carefully review several sales offers to understand the average cost of your chosen equipment. If the price of the offer you like is much lower than similar offers, think about it. A significant price difference may indicate hidden defects or an attempt by the seller to commit fraudulent acts.
Do not buy products which price is too different from the average price for similar equipment.
Do not give consent to dubious pledges and prepaid goods. In case of doubt, do not be afraid to clarify details, ask for additional photographs and documents for equipment, check the authenticity of documents, ask questions.
The most common type of fraud. Unfair sellers may request a certain amount of advance payment to “book” your right to purchase equipment. Thus, fraudsters can collect a large amount and disappear, no longer get in touch.
- Transfer of prepayment to the card
- Do not make an advance payment without paperwork confirming the process of transferring money, if during the communication the seller is in doubt.
- Transfer to the “Trustee” account
- Such a request should be alarming, most likely you are communicating with a fraudster.
- Transfer to a company account with a similar name
- Be careful, fraudsters may disguise themselves as well-known companies, making minor changes to the name. Do not transfer funds if the company name is in doubt.
- Substitution of own details in the invoice of a real company
- Before making a transfer, make sure that the specified details are correct, and whether they relate to the specified company.
Seller's contacts
+41 32 373 ...
Show
+41 32 373 34 44
+41 79 758 ...
Show
+41 79 758 03 25
Switzerland 
50 Hz
Switzerland, Brugg
Number of spindles 1
Table length 770 mm
Table width 90 mm
Longitudinal travel (X-axis) 450 mm
Transversal travel (y-axis) 70 mm
Vertical travel (z axis) 310 mm
Drill capacity 1 mm
Max. taping diameter M 8
Tool changer:
Number of tools 4
Tool diameter max. 47 mm
Diameter with free adjacent pockets 100 mm
Tool lenght 160 mm
Max. tool-weight 1. kg
Time of tool changing 0.8 / .3 sec
Average chip-to-chip time . sec
Spindle nose: HSK-A 40 DIN 69893
Spindle speeds:
up to 30000 rpm
Rapid traverse: 75 m/min
Air connect 6 bar
Voltage 50 Hz 3x 400 Volt
Spindle motor 7 kW
Total power required 14 kW
Various accessories:
Tool break control
Status light
Interface serial port RS 3
Switch cabinet Air conditioner
Controller: GE Fanuc Series 18i-MB5